Operation Manual

200
Changing Additional Settings
7
3 Press the 3 button.
The screen that was displayed before selecting the menu item appears
again.
You can set the monitor to dim and the camera to turn off automatically if
unused for a certain length of time.
Set in [Power Saving] and [Auto Power Off] of the [R Set-up 2] menu.
Pixel Mapping is a function for mapping out and correcting defective pixels
in the CMOS sensor.
Attach a proper lens to the camera before performing pixel mapping.
1 Select [Pixel Mapping] in the [R Set-up 3] menu, and press
the four-way controller (5).
The [Pixel Mapping] screen appears.
Minimizing Battery Consumption
Power Saving
The monitor brightness goes dim if the camera is unused for
a while in standby mode. The default setting is O (On).
Press any button to return it to the normal brightness.
Auto Power
Off
The power turns off automatically. Select from [1min.] (default
setting), [3min.], [5min.], or [Off].
Perform any of the following operations to reactivate the camera.
- Turn the camera off and on again.
- Press the shutter release button halfway.
- Press the N button, 3 button, or M button.
• The Power Saving function does not work while a movie is being recorded or
while the AC adapter is connected to the camera.
• The Auto Power Off function does not work when a slideshow is played back,
or when the camera is connected to a computer with an USB cable.
Correcting Defective Pixels in the CMOS Sensor
(Pixel Mapping)
K-01_OPM_ENG.book Page 200 Wednesday, February 22, 2012 2:08 PM