Operation Manual

107
Shooting Functions
4
3 Use the four-way controller (45) to select h.
4 Press the four-way controller (3),
use the four-way controller (45)
to select h or i, and press
the 4 button.
The remote control receiver on the front
of the camera will blink and the camera is
in a standby status.
5 Press the shutter release button halfway.
The autofocus system operates.
6 Point the remote control unit
towards the remote control receiver
on the front of the camera, and
press the shutter release button
on the remote control unit.
The maximum operating distance of the
remote control unit is about 4 m from the
front of the camera.
After a picture is taken, the remote control receiver lights for 2 seconds
and then returns to blinking.
• By default, you cannot adjust the focus with the remote control unit. Focus on
the subject first with the camera before operating with the remote control unit.
When [11. AF with Remote Control] (p.76) is set to [On] in the [A Custom
Setting 2] menu, you can use the remote control unit to adjust the focus.
• Select 9 (Single Frame Shooting) in the Drive Mode setting screen to cancel
shooting with a remote control unit. The setting is canceled automatically
when the camera is turned off if [Drive Mode] is set to P (Off) in [Memory] of
the [A Rec. Mode 3] menu. (p.201)
• The Shake Reduction function is fixed to R (Off).
• Shooting with a remote control unit may not be available in backlit conditions.
• When using the Remote Control Waterproof O-RC1, the autofocus system
can be operated with the S button. The { button cannot be used.
• The Remote Control F can send a remote control signal about 30,000 times.
Contact a PENTAX Service Center to replace the battery (this will involve a fee).
Cancel
Cancel
MENU
Remote Control
Remote Control
OK
OK
OK
4 m
K-01_OPM_ENG.book Page 107 Wednesday, February 22, 2012 2:08 PM