Owner`s manual

Operating Procedure 37
4
[Clear Patient (F3)]: Display the [Patient Information] screen.
• Pressing the [J] key closes the configuration screen and displays a
confirmation screen for resetting patient information.
•Use the [K] or [L] key to select [YES] and press the [Enter] key to close
the message and clear the patient information.
• If you select [NO] or do not perform an operation for at least 5 seconds,
the message closes without any patient information being cleared.
[User List (F4)]: Display the [User List Preset] screen.
• Pressing the [J] key closes the configuration screen and displays the
[User List Preset] screen.
• Perform [User List Preset] screen operations in the same way as when
you display the screen by pressing the [User] key.
I "[User] Key" (P.32)
[Noise Reduction (F5)]: Change the noise reduction setting.
• Pressing the [J] key closes the configuration screen and displays the current noise reduction setting on the monitor for
about 3 seconds.
•
Change the noise reduction setting in the same way as when you change the setting by pressing the [Noise reduction] key.
I "[Noise reduction] Key" (P.32)
[Setting Menu (F6)]: Display the [Setting Menu] screen.
• Pressing the [J] key closes the configuration screen and displays the [Setting Menu] screen on the monitor.
• Perform [Setting Menu] screen operations in the same way as when you display the screen by pressing the [Setting
menu] key.
I "[Setting menu] Key" (P.33)
[Enhancement (F7)]: Change the enhancement setting.
• Pressing the [J] key closes the configuration screen and displays the current enhancement setting on the monitor for
about 3 seconds.
• Change the enhancement setting in the same way as when you change the setting by pressing the [Enhance level] key.
I "[Enhancement] Key" (P.33)
[Zoom (F8)]: Change the magnification setting.
• Pressing the [J] key closes the configuration screen and displays the current magnification setting on the monitor for
about 3 seconds.
• Change the magnification setting in the same way as when you change the setting by pressing the [Zoom] key.
I "[Zoom] Key" (P.33)
[Contrast (F9)]: Change the contrast setting.
• Pressing the [J] key closes the configuration screen and displays the current contrast setting on the monitor for about
3 seconds.
• Change the contrast setting in the same way as when you change the setting by pressing the [Contrast] key.
I "[Contrast] Key" (P.34)
[Stop Watch (F11)]: Operate the stop watch.
• Pressing the [J] key closes the configuration screen and displays the sub-menu for the stop watch.
• Operate the stop watch in the same way as when you change the settings by pressing the [Stop Watch] key.
I "[Stop watch] Key" (P.38)
[Film Counter Reset (F12)]: Reset the film counter.
• Pressing the [J] key closes the configuration screen and changes the film counter indication on the monitor to [1].
• You can also reset the film counter by pressing the [Clear counter] key.
I "[Film counter reset] Key" (P.38)
Do you want to reset this patient data?
YES
NO
Confirmation Screen for Resetting
Patient Information