Owner`s manual

24 Operating Procedure
4
4 Operating Procedure
1 Turn on the power switch on the front panel of the
processor. (Refer to Figure 4.1)
• The processor turns on and the screen for normal mode
appears on the monitor.
I "Normal Screen" (P.24)
• The patient information from the last time the processor was
used will be displayed on the monitor.
2 Turn off the power switch when you want to turn off
the power.
CAUTION
J Normal Screen
The normal screen shown below appears on the monitor when you turn on the processor.
You can change which items appear on the normal screen in the [Display] settings.
I"Settings in the [Display] Tab" (P.35)
Turning On/Off the Processor
z Do not turn the power off and then on again within a short period of time. Doing so may blow a fuse.
I "Replacing the Fuses" (P.46)
z Do not use a sharp object such as the tip of a pen to press the keys on the front panel.
z Do not use the end of the scopes' light guide to operate the keys or switches.
Monitor Screens
Figure 4.1
NAME
:
AGE
:
SEX
:
ID
:
Dr.
:
Facility
:
XX-XXX
Comment
:
MIRROR
1
08/08/07
15
:
02
:
35
Date
Time
(Hours/Minutes/
Seconds)
Patient’s Name
(Up to 24 Characters)
ID
(Up to 12 Characters)
Comment
(Up to 40 Characters)
Doctor’s Name
(Up to 12 Characters)
Facility
(Up to 12 Characters)
Age (Up to 3 Characters) Sex (1 Character)
Image Direction
Film Counter
Scope Name