Owner`s manual

18 Preparation

Connect a scope to the processor. Use a scope with a water bottle and suction unit connected to the scope. You can connect

a PENTAX K-series video endoscope (P.50) to the processor. For details on the scope, refer to the owner’s manual for the

scope.

Align the scope locking lever of the processor to the

OPEN position. (Refer to Figure 2.1)

Insert the electrical connector and light guide of the

scope into the corresponding scope electrical

connector and light guide attachment of the

processor and move the scope locking lever in the

direction of

2 until it clicks into the LOCK position.

Attach water bottle assembly, 2/3 filled with sterile water, to the appropriate location on the left

side of the video processor.

NOTE

• Align the A/W-DRAIN lever to the A/W (air/water supply)

position. (Refer to Figure 2.2)

• Insert the air/water connector into the holder of the cap until the

scope is connected. (Refer to Figure 2.3)

Connecting an Endoscope

z Do not over tighten the cap.

z Replace the sterile water every day.

z Be sure to use sterile water.

Scope

Locking

Lever

Electrical

Connector

Light Guide

Figure 2.1

A/W

DRAIN

Figure 2.2

Figure 2.3