Operation Manual

1 Firstly, set a channel of this flash unit, and register it on the

camera.

1 Turn the camera off and then attach this flash unit to the

hot shoe of the camera.

2 Turn on the power switch (ON).

3 Press the flash mode button (MODE) a number of times

to display P-TTL MASTER on the LCD panel.

4 Press the setting button (SET) and rotate the

adjustment dial to display SLAVE.

5 Press the setting button (SET) to complete the setting.

6 Set a channel (CH1 through CH4) from the function

menu.

• Refer to “Using the Function Menu” (page 36) for

details on the function menu.

7 Press and hold the function button ( ) to complete

the setting.

8 Turn the camera on and press the shutter release button

halfway down. The channel is registered on the camera.

• SLAVE cannot be selected while the camera’s

exposure metering timer is on (while information

relating to aperture, etc., is displayed in the

viewfinder).

Using This Flash Unit in Combination with a Built-in Flash Unit

of the Camera

Wireless mode

(SLAVE)

213

AF360FZ_540FGZ.book Page 41 Friday, December 20, 2013 6:11 PM