Operation Manual

n Wireless Mode (P-TTL)

1 Turn on the power switch (ON).

2 Press the flash mode button (MODE) to display

P-TTL MASTER on the LCD panel.

3 Press the setting button (SET) to blink the wireless mode

setting.

4 Rotate the adjustment dial to select the desired setting from

MASTER/CONTROL/SLAVE.

5 Press the setting button (SET) to complete the setting, and

take a picture after confirming the Ready lamp is lit.

• When SLAVE is selected, the Ready lamp blinks after the

flash unit is fully charged.

• If you select MASTER or SLAVE, you can configure

settings of flash output compensation and flash output by

pressing the setting button (SET).

• Refer to “Advanced Functions” (page 40) on how to use

wireless mode.

Wireless mode (P-TTL)

AF360FZ_540FGZ.book Page 28 Friday, December 20, 2013 6:11 PM