Use and Care Manual

FILTER ATTACHMENT
The initial few gallons of water will contain carbon nes and may soil your shower stall. It’s a good idea to place a container
underneath the shower lter to catch the rst few gallons of water. This carbonized water is great for plants; it can be safely
discarded in a plant bed or down the drain.
Notice
FLUSH FILTER
1. Wrapplumberstapeve(5)orsix(6)aroundthe
shower pipe.
2.Attachtheshowerlterbodytothesideoftheshower
 pipewiththechromecollar.(FigureB)
3. Turn clockwise to tighten.
4. Use a pair of pliers to turn the chrome collar until the
 ltersystemisrmlytightened.
Figure B
Do not over tighten the chrome inlet collar. Overtightening
may cause the washer to compress into the inside of the
shower pipe, resulting in leakage around the connector. If
this occurs, unscrew the chrome inlet collar from the pipe,
reinstall the washer and reconnect the shower pipe.
Caution
Flush and Activate Filter Until Water Runs Clear.
1.Usecoldwaterfortheinitialushing.Afterthewaterhasturnedclear,adjustthetemperatureuptoanormalshower 
 temperature.(Pleasesee“Note”below)
2.Noticethatthereisaslightdelayintemperatureadjustmentduetothevolumeofwaterinthelter;takethisdelayinto 
 accountwhenmakingtemperatureadjustments.Makeslightadjustmentsandwait30secondsfortemperaturechange.
Run water until clear and then turn off and back on several times. Repeat this procedure until the initial surge of water
is free of discoloration.
SHOWER HEAD ATTACHMENT
Attachtheshowerheadtothelter.(FigureC)
Figure C
DO NOT use a shower head or wand with a shut off valve.
Caution
Ensure the rubber washer is in place in the chrome inlet collar.
Caution
PREMIUM CHROME SHOWER FILTER • 3