User Guide

7
INTELLIFLO3™ VSF and INTELLIPRO3™ VSF Variable Speed and Flow Pump User's Guide
DirectConnect
PumpDashboard˃DeviceSettings˃DirectConnect.
Place your pump into Direct Connect mode to program and operate your
pump without a WiFi connection via a Bluetooth
®
wireless technology
connection.
To setup and operate the pump through Direct Connect your phone must
be within Bluetooth range of the pump and the phone's Bluetooth must be
enabled.
SET-UPWIFI:Tap to establish a WiFi internet connection between your
phone and the pump. WiFi will now be your primary connection.
ALWAYSUSEDIRECTCONNECT:Tap to ensure your pump and
phone will communicate in Direct Connect Mode when within range of
each other.
DISCONNECT: Tap to disconnect your Bluetooth wireless connection.
Note: When restarting the pump after a power outage or after it has been
powered o󰀨, the Connect LED will pulse yellow. This indicates that the
pump needs to be re-paired with your smartphone. Press the CONNECT
button to allow your smartphone to recognize the pump.
Relays
PumpDashboard˃DeviceSettings˃Relays
The following functionality is only available if the Relay Control
Board (P/N 356365Z -- sold separately) has been installed.
The relay board includes two high-voltage terminals capable of
controlling pool lights, salt chlorine generators or other ltration
system components. One terminal is intended for 5A max low-
current connections and the other for 16A max high-current
connections.
1- DeviceType: Select the device connected to a particular relay.
•  RELAY1Options: Lights, Salt Cell or Other
•  RELAY2Options:Lights, Salt Cell, Booster Pump or
Other
2− DeviceNickname: Enter the name you want your device to
display on Program Setup screens.
3− Speed/FlowDependent: Check this box to ensure the relay is
only activated when the pump is running.
4− Add/Remove: Tap to add or remove a relay.
FIGURE 10
FIGURE 11
1
2
3
4