User Manual

INTELLIMASTER Variable Speed Controller User Manual
5
PARALLEL OPERATION
To set parallel operation, change the operation method to the auto operation mode.
NOTE: Up to 3 pumps can be linked and operated in parallel.
Parallel Operation
1-4
- 5 -
To set parallel operation, change the operation method to the auto operation mode.
*Note: Up to 3 pumps can be parrallel operated.*
Master Inverter
(Auto Mode)
Slave Inverter 2
(Auto Mode)
Slave Inverter 3
(Auto Mode)
Press the
+
buttons for 2-3 seconds.
be turned on with linkage operation.
1. Setting the master pump : Press the for a duration 2-3 seconds.
The Master pump should state "1"
2. Setting the slave pump : Press the for a duration 2-3 seconds.
The Slave pump should state "2".
+
+
RS485 connection guide
Parallel Operation
1-4
- 5 -
To set parallel operation, change the operation method to the auto operation mode.
*Note: Up to 3 pumps can be parrallel operated.*
Master Inverter
(Auto Mode)
Slave Inverter 2
(Auto Mode)
Slave Inverter 3
(Auto Mode)
Press the
+
buttons for 2-3 seconds.
be turned on with linkage operation.
1. Setting the master pump : Press the for a duration 2-3 seconds.
The Master pump should state "1"
2. Setting the slave pump : Press the for a duration 2-3 seconds.
The Slave pump should state "2".
+
+
RS485 connection guide
Press the + buttons for 2-3 seconds
to turn on multipump parallel operation.
Master Inverter
(Auto Mode)
Slave Inverter 2
(Auto Mode)
Slave Inverter 3
(Auto Mode)
Setting the MASTER PUMP : Press the + for a duration 2-3 seconds.
The Master pump should state “ 1 ”
Setting the SLAVE PUMP : Press the + for a duration 2-3 seconds.
The Slave pump should state “ 2 ”