User Guide

ScreenLogic2

Interface User’s Guide

Setting up a Two-Speed Pump

Equipment circuits displayed on this screen will automatically switch a two-speed filter pump to high speed when

these circuits are switched on. For example you can have the Filter pump switch to high speed whenever the JETS

or CLEANER is on.

To assign a two-speed pump to a circuit:

1. Start the ScreenLogic2 Interface Configurator and tap Configure the ScreenLogic2 Interface.

2. Tap Next on the General Setting page and on the Setup Circuits page. The Configure Other Equipment

(Step 3 of 5) page is displayed.

3. Scroll through the previously assigned circuit names to

add another circuit for switching filter pump to high

speed. Select a circuit to assign to a high speed pump

from the Add a circuit box. Continue to add another

circuit. You can use a Feature Circuit as one of the

circuits which can switch the pump to high speed.

Note: With a dual equipment IntelliTouch

Control

System i10+3D, one circuit button is assigned to

control the spa pump and the pool pump. For more

details, refer to “Configure Other Equipment (Step 3

of 5),” page 35.

4. Repeat step 3 for each circuit requiring a two speed

pump.

5. Tap Finish when done.

Setting up Additional Equipment

The following describes how to set up any special equipment that may be attached. Your system may or may not

have this equipment installed.

The following information describes:

• Setting up a two-speed pump - Setup circuits that switch the filter pump from low to high speed.

• Setup Solar equipment - Enable solar or heat pump.

• Cool-down cycle for the heater - Set a cool-down cycle for heaters that require it.

• Enable “Spa Manual Heat” control - Heats the spa using the Spa button on the ScreenLogic2

Interface

Main screen or the spa-side control, even when the heater is set to OFF in the Heat screen. This lets the

homeowner heat the spa on-demand. Timed programs will not heat the spa.