User Guide

15
ScreenLogic2
®
Interface User’s Guide
1
234
WAN
Connecting without Broadband Internet Access
This connection setup is for homeowner’s that do not have a Broadband Internet connection.
To connect the ScreenLogic2 Interface hardware:
1. Connect the Protocol adapter to the existing wireless router: Connect an Ethernet cable (CAT 5) to the
Ethernet RJ45 jack located on the Protocol adapter. Connect the other end of the Ethernet cable to LAN
Port 1 on the back panel of the wireless router. The LED indicator for LAN Port 1 will be on to indicate
proper connection. Ensure that a straight-through CAT 5 cable is used to connect to the wireless router. A
crossover Ethernet cable will not work.
2. Connect to the PC: Insert a separate Ethernet cable (CAT 5) to the LAN Port 2 on the back panel of the
wireless router, and to an available Ethernet port on the network adapter in the computer. Use a straight-
through CAT 5 cable to connect to the wireless router. The LAN Port 2 LED indicator will be lit to indicate
proper connection.
3. Connect to the Protocol adapter: Proceed to “Connect to the Protocol Adapter,” page 18.
Four-wire
(22 gauge)
(Connects to
the Personality
board)
IntelliTouch
®
or
EasyTouch
®
Control System
Load Center
(Located outside at
equipment pad)
Protocol Adapter
Ethernet cable
(RJ45 - CAT 5)
Wireless router
In-wall Touch Screen
Existing PC
Cable Distant Limits:
• Ethernet cable distance limit = 300 feet
• Four-wire cable distance limit = 1500 feet
Wireless Digital Tablet
Note: (*) Optional wiring for existing Indoor Control Panel. Tap into the Indoor Control Panel
connector or pig tail off the four-wire cable connected to the Personality board.
Indoor Control Panel *