User's Manual

2
EasyTouch Wireless Control Panel Installation and User’s Guide
EasyTouch Wireless Control Panel Overview
The EasyTouch Wireless Control Panel makes it easy for you to control your pool and spa daily operations
from inside your home. Using the “Pool” and “Spa” buttons allows one touch control to heat and filter your spa
and pool. EasyTouch automatic system operations can be performed either at the Wireless Control Panel or
from the outdoor control panel. The Wireless Control Panel connects to the motherboard in the EasyTouch
load center.
For details about the
control panel LCD
status messages, see
page 5.
AUTO HEATER
SPA 100°F / 95°F
AIR 70°F FRZ
MON 09:30 AM
AUTO HEATER
SPA 100°F / 95°F
AIR 70°F FRZ
MON 09:30 AM
Circuit LED.
Circuit name
label.
Spa (Hi-Temp) Button: Switches the
filter pump on, rotates valve actuator
(to isolate spa water from pool
water), and switches the heater on.
Hi-Temp (EasyTouch single body
system) sets the high temperature
settings for the spa, see page 39.
Circuit LED.
Circuit name label.
Spa (Hi-Temp) Button:
Switches the filter pump on,
rotates valve actuator (to
isolate spa water from pool
water), and switches the
heater on. Hi-Temp
(EasyTouch single body
system), Can be assigned for
high temperature settings,
see page 39.
Pool (Lo-Temp) Button:
Switches the filter pump on,
rotates valve actuator (to isolate
pool water from spa water), and
switches heater on.
Lo-Temp (EasyTouch single body
system) sets the low tempera-
ture settings for the pool, see
page 39.
Pool (Lo-Temp) Button:
Switches the filter pump on,
rotates valve actuator (to
isolate pool water from spa
water), and switches heater
on.
Lo-Temp (EasyTouch single
body system), can be as-
signed for low temperature
setting, see page 39.
Wireless Control Panel (EasyTouch 8) - (P/N 520547)
Wireless Control Panel (EasyTouch 4) - (P/N 520546)
Seven user defined
auxiliary circuits.
Buttons switch the
assigned circuit
function on/off (12
hour time-out). If solar
equipment is not being
used, use the AUX
EXTRA (Down arrow
button) for an
additional circuit (see
page 4 for details).
Three auxiliary buttons
switch the assigned
circuit function on/off
(12 hour time-out). If
solar equipment is not
being used, use the
AUX EXTRA (Down
arrow button) for an
additional circuit (see
page 4)
Power ON, Menu/Back button,
see page 4.
Set Temperature buttons,
see page 4.
Set Temperature buttons,
see page 4.
Power ON, Menu/Back
button,
see page 4.