User's Manual

EasyTouch Wireless Control Panel User’s and Installation Guide

IMPORTANT SAFETY PRECAUTIONS (Continued)

General Installation Information

1. All work must be performed by a licensed electrician, and must conform to all national, state, and local

codes.

2. Install to provide drainage of compartment for electrical components.

3. If this system is used to control underwater lighting fixtures, a ground-fault circuit interrupter (GFCI)

must be provided for these fixtures. Conductors on the load side of the ground-fault circuit-interrupter

shall not occupy conduit, junction boxes or enclosures containing other conductors unless such

conductors are also protected by a ground-fault circuit-interrupter. Refer to local codes for details.

4. A terminal bar stamped is located inside the supply terminal box. To reduce the risk of electric

shock, this terminal must be connected to the grounding means provided in the electric supply service

panel with a continuous copper wire equivalent in size to the circuit conductors supplying this

equipment (no smaller than 12 AWG or 3.3 mm). The bonding lug(s) provided on this unit are intended

to connect a minimum of one No. 8 AWG for US installation and two No. 6 AWG for Canadian

installations solid copper conductor between this unit and any metal equipment, metal enclosures or

electrical equipment, metal water pipe, or conduit within 5 feet (1.5 m) of the unit.

5. The electrical supply for this product must include a suitably rated switch or circuit breaker to open all

ungrounded supply conductors to comply with Section 422-20 of the National Electrical Code, ANSI/

NFPA 70.1987. The disconnecting means must be readily accessible to the tub occupant but installed

at least 10 ft. (3.05 m) from the inside wall of the pool.

6. Supply conductor must be sized to support all loads. Maximum supply conductor current must

be 125 Amps at 125 VAC.

Canada - Industry Canada (IC) - This device complies with RSS210 of Industry Canada. (1999).

Operation is subject to the following two conditions: (1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired

operation of the device.

FCC Standard - 47 CFR Part 15, Subpart C (Section 15.247). This version is limited to chapter 1

to chapter 11 by specified firmware controlled in the U.S.A.

Instruction to user - This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

Note: The user is cautioned that changes and modifications made to the equipment without the

approval of the manufacturer could void the user’s authority to operate this equipment.