User's Manual

EasyTouch Wireless Control Panel User’s and Installation Guide

Settings Menu: QuickTouch (QT4) Wireless Remote

The QuickTouch QT4 wireless remote controller provides switching of up to four circuits. For example, you

can use the QT4 wireless remote to activate the spa circulation, and for operating three auxiliary pieces of

equipment (such as heat enabled, lights, jet pump, heat boost, air blower, waterfall, etc.).

Each of the four functions on the QT4 wireless controller has an on and an off button. To switch a circuit on

or off, press and hold the appropriate button for at least a full second.

The QT4 buttons can be assigned to any available circuit. However, the QT4 has the following preset circuits

assigned to the four buttons:

• Spa button activates the spa circuit.

• A button activates Auxiliary 1 circuit.

• B button activates Auxiliary 2 circuit.

• C button activates Auxiliary 3 circuit.

Assign QT4

To assign circuits to the QuickTouch wireless controller buttons:

Up/Down buttons: Select a circuit to assign to one of the QuickTouch wireless

remote buttons. You can set up to four circuits (1/4, 2/4, 3/4, 4/4).

Right button: Move to the circuit setting.

Up/Down buttons: To configure the first button on the QuickTouch wireless remote,

scroll through the circuit names and find the circuit that you would like to assign to the

first button on the QT4. The circuits selections are: None, Spa, Pool, Aux 1-7, Heat

Boost, Heat Enable, (EasyTouch 8). None, Spa, Pool, Aux 1-3, Heat Boost, Heat

Enable (EasyTouch 4). Note: The “Heat Boost” feature will switch on the heater for

seven minutes to increase the spa water temperature. Each time the spa Heat Boost

button is pressed, the temperature will increase about 1

° F. The temperature will not

go beyond the 106° F limit.

Right button: Assign the next circuit (2/4).

Up/Down buttons: Select the first digit for the circuit number (1/4, 2/4, 3/4, 4/4),

then repeat the procedure for the other three buttons.

Menu/Select: Press this button to save settings and to return to the Settings menu

options. Press the button again to return to the main menu options or press again to

return to the Main screen.

▼ SETTINGS ▼ QUICKTOUCH ASSIGN QT4

Getting There

▲

Assign QT4 1/4

Circ: [Spa]