User's Manual

31
EasyTouch Wireless Control Panel User’s and Installation Guide
Settings Menu: 2-Speed Pump
Equipment circuits selected in this menu will automatically switch a two-speed filter pump to high speed when
these circuits are on. If a two-speed pump is assigned to solar, a cleaner or a pump, when activated the pump
will automatically run for five minutes in high speed then switch to low speed. For example, when on, the filter
pump will switch to high speed whenever the JETS or CLEANER is on. There must be a two-speed relay
installed in the EasyTouch Load Center in order for the “2-Speed Pump” menu settings to function.
2-Speed Pump
To configure a two-speed pump to a circuit:
Up/Down buttons: Select a circuit that will switch the filter pump to high speed. You
can set up to four circuits to use a 2-speed pump (1/4, 2/4, 3/4, 4/4).
Right button: Move to assign a circuit setting.
Up/Down buttons: Select the circuit to assign to a two-speed pump. The circuits
selections are: None, Spa, Pool, Aux 1-7, Solar, Heater, Pool Heater, Spa Heater,
Freeze (EasyTouch 8). None, Spa, Pool, Aux 1-3, Pool, Solar, Heater, Pool Heater,
Spa Heater, Freeze (EasyTouch 4).
Right button: Assign the next circuit (2/4).
Up/Down buttons: Select the first digit for the circuit number (1/4, 2/4, 3/4, 4/4).
Right button: Move to circuit setting.
Up/Down buttons: Select the next circuit. When finished press Menu/Select.
Menu/Select: Press this button to save settings and to return to the Settings menu
options. Press the button again to return to the main menu options or press again to
return to the Main screen.
Settings Menu: Solar
Use the solar settings to setup solar or configure solar as a heat pump:
Setting Up Solar Control: Ensure that the solar temperature sensor is installed.
About Installing Solar Heating: First, install the solar sensor at the collectors and connect to the EasyTouch
load center. If “HEAT PUMP” is selected and is being used in place of a solar heating system, install Solar
sensor near the EasyTouch Load Center. Connect the wires to the SOLAR screw terminals. Plug the solar
valve actuator cable into 3-pin socket marked VLV A on the motherboard. If solar booster pump is being
installed, connect pump to a power relay and plug low voltage cable from relay into 2-pin socket marked
SOLAR.
▼ SETTINGS ▼ Solar Solar
Getting There
▲
▼ SETTINGS ▼ 2-Speed Pump 2-Speed Pump
Getting There
▲
T
S
2-Speed Pmp 1/4
Circuit:
[SPA HEATER ]