User's Manual

25
EasyTouch Wireless Control Panel User’s and Installation Guide
Settings Menu: IntelliChlor
The IntelliChlor electronic chlorination system must be connected to the EasyTouch system to use the
following IntelliChlor settings. While in normal operating mode (“Pool,” “Spa” mode or “Spa Fill (Spillway),”
EasyTouch will control the chlorinator output level. When IntelliChlor is connected to the EasyTouch outdoor
control panel, chlorination levels can only be changed from the EasyTouch outdoor control panel, indoor control
panel or wireless control panel. The amount of chlorine introduced into the pool is determined by the amount of
salt in the water, water temperature, and the amount of time the pool operates in “Pool” mode. Note: While in
“Freeze Protection” mode, IntelliChlor will not operate during the time that the filter pump is operating. For
more information, refer to the IntelliChlor Electronic Chlorine Generator User’s Guide (P/N 520589).
IntelliChlor
To setup the IntelliChlor system:
Right button: Move to Enable/Disable settings. (To select the second page settings,
press the Up/Down button to change the first digit to 2/2).
Up/Down buttons: Select Ye s or No to enable or disable the IntelliChlor system.
Right button: Move to the “Level” settings.
Up/Down buttons: Set the chlorination output level for the pool/spa water from 0 to
100%. EasyTouch will determine the chlorinator output level when the system is
operating in “Spa” or “Pool” mode. The amount of chlorine introduced into the pool/
sap is determined by the amount of salt in the water, water temperature, and the
amount of time the pool/spa operates in these modes mode.
Right button: Move to the next page settings (2/2).
Up/Down buttons: Select 2/2.
Right button: Move the Super Chlorination settings.
Up/Down buttons: Set Super Chlorination On or Off. See note below about Super
Chlorination.
Right button: Move to “Run Hours” setting.
Up/Down buttons: Set the number of hours to run Super Chlorination. 24 hours is
the default setting. Run hours can be set from 0 to 72 hours.
Menu/Select: Press this button to save settings and to return to the Settings menu
options. Press the button again to return to the main menu options or press again to
return to the Main screen.
Note: For IntelliChlor status messages, see “Diagnostics: Chlorinator” on
page 39.
About Super Chlorination: The Super Chlorination feature is used to introduce large amounts of chlorine
into the pool water if there has been heavy rain fall, many bathers in the pool, cloudy water conditions, etc.
When Super Chlorination is enabled, the system will switch on the filter pump, set the pool/spa valves to the
correct position, and set the IntelliChlor chlorine generator to maximum output. This process continues for 24
hours. At the end of the Super Chlorination process, the pool will return to normal operation. It is possible to
manually stop the Super Chlorination process and switch off the filter pump using the Filter (F) button on the
control panel. When the filter pump is switched on again using the Filter (F) button, the Super Chlorine process
will resume for the duration of time left.
IntelliChlor 1/2
Enable: No
Level: 50%
T
S
IntelliChlor 2/2
Super Chlr: Off
Run Hours: 24
S
T
▼ SETTINGS ▼ INTELLICLOR INTELLICHLOR
Getting There
▲