User's Manual

20
EasyTouch Wireless Control Panel User’s and Installation Guide
Schedules Menu
Use the “Schedules” menu to create programs that automatically run equipment like pool filtration or lights.
Any circuit can be programmed to switch on and off at a specific time on every or any specific day of the
week. The number of programs that can be created for circuits are as follows:
• Up to 12 total programs can be created for all circuits combined.
• One circuit can have up to a maximum of 9 programs (9/9), which leaves 3 programs that can be
used by one circuit or three separate circuits for a total of 12 programs.
Using the Schedules menu
Use the “Schedules” menu to program operating schedules for the pool, spa and auxiliary circuits:
Choose the circuit to program
Up/Down button: Select the circuit (generic names shown) to program: Spa, Pool,
AUX 1 - AUX 3 (EasyTouch 4), AUX 1 - AUX 7 (EasyTouch 8).
The current number of programs for each circuit is displayed opposite the circuit
name. A circuit can have up to 9 programs (9/9). Three additional programs can be
assigned to another circuit or three separate circuits for a maximum of 12 programs.
Create a new program
The current number of programs for each circuit is indicated opposite to the circuit
name. 0/0 indicates no programs assigned to this circuit.
Right button: To move to the “Mode” selection.
Up/Down button: Select New to create a new program. Use “None” when a circuit
has existing programs and you wish to exit the “Mode” selections without modifying
the existing programs.
Choose the type (Mode) of program to run
After selecting “New” the current program number (1/1) for this circuit is displayed.
Right button: To move to the “Mode” selections.
Up/Down button: Choose the program to run: Schedule, Egg Timer, Once Only,
New, Delete, and None. If there are existing programs assigned to this circuit, use
these buttons to view and select the existing program settings.
Mode Selection:
Schedule: Set start, stop times and the day(s) of the week to automatically switch
pool/spa circuits on or off. Default run time for the “Schedule” feature is 8:00 AM to
5:00 PM. If you program the start and stop times the same the schedule is will run for
24 hours.
Egg Timer: A one time program that switches on a function at a specific time, and
counts down the pre-set time to the switch off the function. After the “Egg Timer”
schedule has finished, the system can be operated in manual mode. The “DON'T
STOP” option allows a circuit to run continuously until its switched off manually.
Once Only: Schedule a circuit to switch on at a particular time on a one-time basis.
New: press the Right button to create a new program.
Delete: Select the program and press the Right button to delete it.
None: Press the Right button to exit the “Mode” selections without modifying the
program.
Spa 0/0
Mode: None
S
Spa 0
Pool 0
Aux 1 0
Aux 2 0
T
S
X
Spa 1/1
Mode: Egg Timer
Timer: 12:00
T
S
Spa 1/1
Mode: Once Only
08:00A
s
m t w t f s
T
S
_ _ _ _ _ _ _
Spa 1/1
Mode: Schedule
08:00A - 05:00P
s
m t w t f s
T
S
_ _ _ _ _ _ _
Spa 1/1
Mode: Delete
T
S
Spa 1/1
Mode: None
T
S
Spa 0/0
Mode: New
T
S
Getting There
▼ SCHEDULES SPA
▲
Spa 1/1
Mode: New
T
S