User's Manual

EasyTouch Wireless Control Panel User’s and Installation Guide

Lights Menu

From the Lights screen you can manually switch all lights on or off, and synchronize colored lights. If you

have at least two Pentair SAm and/or SAL, and/or FIBERworks lighting systems you can use the Sync feature

to change the lighting settings. This feature require a separate auxiliary relay circuit for each light. Up to four

lights can be assigned on each auxiliary circuit for a total of 12 lights that can be independently controlled from

the Lights menu.

Make sure the AUX relay circuits which control your lighting have been assigned names. Then verify that

SAm and/or SAL, and/or FIBERworks have been set up in “Circuit Types” as SAM or SAL lights. If

FIBERworks lighting is incorporated, it also has to be set up as a “PHOTON GENERATOR” for the circuit

controlling the light bulb, and COLOR WHEEL for the circuit controlling the color wheel. For more

information about setting up lights, see “Settings Menu: Circuit Types,” on page 28.

Lights

To configure lights:

Up/Down button: Select: All off, All on, or Sync.

Menu/Select: Press this button save settings and to return to the main menu items or

press the button again to return to the Main screen.

The lights options are:

All Off: Switch all lights off manually.

All On: Switch all lights on manually.

Sync: Causes all colored lights to synchronize their colors.

Setup Lights

Mode: All Off

Getting There

LIGHTS SET UP LIGHTS

▲