User's Manual

16
EasyTouch Wireless Control Panel User’s and Installation Guide
EasyTouch Menus
Use the EasyTouch control panel menus to schedule when to heat and filter your pool and spa automatically.
Lights can also be switch on and off. The main screen shows the pool (or spa), temperatures and the system
day and time. The main screen is automatically displayed if there is no menu control panel activity for five
minutes.
The “Settings” and “Schedule” menus are typically used most often for daily spa and pool operations. The
“Settings” menu is used by the pool installer to setup installed equipment which is connected to each output
relay (filter pump, auxiliary relays, heater, valves, lights, etc.). For EasyTouch equipment installation
instructions, see the EasyTouch Installation Guide (P/N 520584).
Main Screen
The main screen shows the mode of operation (AUTO/SERVICE), the heat source
being used. The spa (or pool) actual water temperature (95° F) and the current heater
set point temperature (100° F) are displayed. The current air temperature is also
displayed in either Fahrenheit or Celsius. If the second display line is blank and the
heat source is not displayed, there is no spa or pool function currently active. If the
IntelliChlor salt chlorinator generator option is installed, pool and spa sanitizer settings,
and salt level is shown in the Diagnostics, “Chlorination,” settings.
Main Screen Description
AUTO: EasyTouch is in normal (automatic) operating mode.
HEATER: The selected heat source as selected in the “Heat” menu (see page 18). The heat options are:
•
OFF - No heating even though pump and other circuits may be operating.
•
HEATER - Gas heater only.
•
SOLAR ONLY - Solar heating system to be the only heat source. In order to display “Solar Pref.” on
the main screen, you must first enable solar in the “Solar” menu (see page 31).
•
SOLAR PREF. - (Solar Preferred) - For when solar and gas heating are combined, and you want to
use solar heating only when it is most effective. In order to display “Solar Pref.” on the main screen,
you must first enable solar in the “Solar” menu (see page 31).
SPA: “SPA” is displayed after the “Spa” button has been pressed to switch the filter pump on, rotate the valve
actuator (to isolate spa water from pool water), and switch the heater on (if enabled in the “Heat” menu). The
temperature unit displayed on the left side is the actual water temperature (95° F) and the set point
temperature (100° F) as set in the “Heat” menu is displayed on the right side. Degree units are displayed in
either Fahrenheit or Celsius (see page 33). If this display line is blank, it indicates no spa or pool function is
currently active.
POOL: “POOL” is displayed after the “P” button has been pressed to switch the filter pump on, rotate the
valve actuator (to isolate pool water from spa water), and switch the heater on (if enabled in the “Heat”
menu). The temperature unit displayed on the left side is the actual water temperature (95° F) and the set
point temperature (100° F) as set in the “Heat” menu is displayed on the right side. Degree units are displayed
in either Fahrenheit or Celsius (see page 33). If this display line is blank, it indicates no spa or pool function is
currently active.
AIR: Displays the actual outside air temperature (70° F) as recorded by the air sensor located near the
EasyTouch load center. Degree units are displayed in either Fahrenheit or Celsius (see page 33).
DAY and TIME: The current system day and time (AM/PM). See the “Clock” menu to set the system day and
time (page 24).
AUTO
AIR 70°F
MON 09:30 AM
AUTO HEATER
SPA 95°F / 100°F
AIR 70°F
MON 09:30 AM