User's Manual

EasyTouch Wireless Control Panel User’s and Installation Guide

6. Set up optional equipment, solar, 2-speed pump (page 31 and 32)

Set up additional equipment such as solar, 2-speed pump, and optional equipment if required. Set up the

control panel to operate with the optional IntelliChlor chlorine generator. To configure EasyTouch for special

equipment:

• Is solar heating available? Is solar being used for a heat pump?

• What circuits will turn 2-Speed pumps to High Speed?

• Cool-down cycle for the heater - Lets you set circuits that switch the filter pump to high speed.

• Do you want to delay turning off the filter pump for 10 minutes when the heater is turned off?

• Do you want the spa to heat whenever the Spa button is pressed?

7. Configuring the heater system options (page 18)

Set the type of heat source being used (Heater, Solar, Solar Preferred).

8. Configure the iS4 spa-side remote, QuickTouch wireless remote buttons (page 33 and 34)

Assign four circuits to the iS4 and/or QuickTouch remote buttons. Once you have checked that all buttons

operate properly, place labels on remote buttons.

9. Set the delays feature (page 32)

Enable the one time “delay” feature for the heater, 2-speed pump, and automatic pool cleaner.

10. Schedule on/off times for circuit (page 21 - 23)

Set times for automatic circuit activation. Up to 12 total programs can be created for all circuits combined.

One circuit can have up to a maximum of 9 programs (9/9), which leaves 3 programs that can be used by one

circuit or three separate circuits for a total of 12 programs. All user created programs are active all the time;

so check that there are not conflicting automated times.

11. Setup the lighting settings (page 17)

From the lighting menu you can enable special control of your pool and yard lighting, such as rotating colored

lights, and synchronized colored lights.