User's Manual

10
EasyTouch Wireless Control Panel User’s and Installation Guide
Switch on lights manually
From the Lights screen you can manually switch all lights on or off, and synchronize colored lights. Up to 12
lights can be controlled. For more information about setting up lights, refer to “Lights Menu” on page 17.
To manually switch on all lights:
Up/Down button: Select: All off, All on, or Sync. The Sync feature allows a
combination of up to 12 SAm, SAL, or FIBERworks lights to synchronize their colors
before switching the lights on.
Menu/Select: Press this button save settings and to return to the main menu items or
press the button again to return to the Main screen.
Using the Once Only timer feature
The Schedules “Once Only” timer feature enables you to automatically switch equipment on for one time. This
feature allows you to program a circuit to turn on at a particular time on a one-time basis. For example, if you
wanted the spa to be heated when you arrive home, you could program the heater to switch on at a specific
time and after you have finished using the spa you can switch the heater off manually. After the program has
run, it is automatically erased. Unlike using the regular “Schedule” program, the “Once Only” program does
not repeat. The circuit must be turned off manually or wait for the 12 hour automatic shut-off. However, you
could also reset the 12 hour factory shut-off by entering an “Egg Timer” count down program to extend past
the default 12 hours shut-off.
The following example describes how to set a “Once Only “ program for the spa. The same steps apply when
selecting the pool or any auxiliary circuit.
Right button: Select the Spa circuit.
Right button: Select Mode if there are existing programs. Skip this step to create a
new program.
Up/Down button: Select New to create a new program.
Right button: To create a new program and enter the “Mode” settings.
Up/Down button: 1/1 indicates that this circuit has one program. If there are existing
programs assigned to this circuit, use these buttons to view and select the existing
program settings.
Right button: To select the “Once Only” settings.
Right button: Move to start time settings.
Up/Down and Right buttons: Set the start hour (A/P) and minutes. A (AM) and
P (PM) time is set when setting the start hour.
Right button: Move to day of the week to run the program.
Right button: Select which day to run the program then press the Up/Down button
to enable the bar on top of the letter. A bar on top of the letter indicates the day
selected to run the program.
Menu/Select: Press this button to save settings and to return to the Schedules menu
options. Press the button again to return to the main menu options or press again to
return to the Main screen.
Setup Lights
Mode: All Off
T
S
Getting There
LIGHTS SET UP LIGHTS
▲
Getting There
▼ SCHEDULES SPA
▲
Spa 0/0
Mode: None (New)
S
Spa 0
Pool 0
Aux 1 0
Aux 2 0
T
S
X
Spa 1/1
Mode: Once Only
08:00A
s
m t w t f s
T
S
_