Operation Manual

horNET Wi-Fi USB Lite (P 6122-07)

Advanced tab

This tab can be used to change advanced wireless network adapter options.

Wireless mode: Select wireless stations to which the adapter can connect.

• 802.11 B allows connecting to 802.11b wireless stations only.

• 802.11 G allows connecting to 802.11g wireless stations only.

• 802.11 B/G mix allows connecting to 802.11b or 802.11g stations.

B/G Protection: If both 802.11b and 802.11g stations exist on the network, it is recommended

that you enable the B/G protection capability.

• Auto: Enables and disables the protected mode automatically, depending on network

status.

• On: Always sends protected frames.

• Off: Always sends unprotected frames.

Tx Rate: Allows the transmit rate to be changed manually. Default value: Auto.

Tx Burst: Selecting this mode may accelerate frame transmission.

Enable TCP Window Size: Selecting this feature may improve TCP performance on wireless

connections.

Fast Roaming at: Switchover between access points will occur when the current access

point’s minimum signal strength threshold set in this field is exceeded.

Select Your Country Region Code: The item selected in this field determines the channels

(frequencies) available.

CCX 2.0: This enables support for Cisco Compatible Extensions.

LEAP turn on CCKM: Using LEAP allows taking advantage of CCKM (Cisco Centralized Key

Management).

Enable Radio Measurement: Enables support for the Radio Measurement feature used in

Cisco network hardware.

Turn off RF/Turn on RF: Disables or enables communications, respectively.

Apply: Applies changes.