Operation Manual

Cerberus Wi-Fi Lite (P6381-0)

Encrypt – This field displays whether security is activated on the wireless

network/device.

Note: If communication to a wireless network is encrypted, you must first

configure the same wireless security settings and then connect to that wireless

network.

Signal – This field displays the signal strength to the wireless network/device.

Refresh – Click Refresh to update this screen.

Connect – Click Connect to establish a connection to the select wireless network.

Help – Click Help to display on-line help information in a pop-up screen.

•

••

• Wireless Basic Settings: Show Active Clients

When you set the Wireless-G Router to work in access point (AP) mode, you can view a

list of connected wireless clients in the Active Wireless Client Table screen.

MAC Address – This field displays the MAC address of a connected wireless client.

Tx Packet – This field displays the number of packets transmitted to this wireless device.

Rx Packet – This field displays the number of packets received from this wireless device.

Tx Rate (Mbps) – This field displays the transmission rate to this wireless device.

Power Saving – The power saving feature allows a computer to stop transmitting

through the wireless adapter during sleep mode. This allows the computer (especially a

notebook) to save energy. This field displays whether this feature is activated on the

wireless client.

Expired Time (s) – By default, the Wireless-G Router disconnects a wireless client after

300 seconds of inactivity (no beacon or data transmission). This field displays the time

that remains before the Wireless-G Router disconnects the wireless connection to the

wireless client. The Wireless-G Router resets this timer back to 300 when a beacon or

data packet is received.

Refresh – Click Refresh to update this screen.

Close – Click Close to close this screen.