Operation Manual

Cerberus Wi-Fi Lite (P6381-0)
17
Setup Wizard: Time Zone Settings
Configure NTP (Network Time Protocol) in the first Setup Wizard screen. NTP allows the
Wireless-G Router to automatically update system date and time from a time server.
Enable NTP client update – Select this option to set the Wireless-G Router as an NTP client
to automatically update the system date and time from a time server on the network. Then set
the fields below. Clear this check box to disable this feature. In this case, logs will not show
the correct system time.
Time Zone Select – Select the time zone of the geographical location in which the Wireless-G
Router is installed.
NTP Server – Select a pre-defined time server.
Cancel – Click Cancel to start configuring the Setup Wizard again.
<<Back – Click <<Back to discard the changes and go back to the previous screen.
Next>> – Click Next>> to continue to the next screen.