Operation Manual

Cerberus P 6381-2

Click the Save button to save this settings.

Blocked DoS Host List – Click this button to open Blocked Host List page, which shows

Host IP Address and Host MAC Address for each host blocked by the router..

Note:

• All of the function in the Advanced Security page won't take effect unless the Firewall

function is enabled.

• The DoS Protection won't take effect unless you enable the Firewall and Current

Statistics Status (which is shown in System Tools / Statistics page) at the same time.

Static Routing

A static route is a pre-determined path that network information must travel to reach a specific

host or network. To add or delete a route, work in the area under the Static Routing page.

Destination IP Address - The Destination IP Address is the address of the network or host

which will use this static route.

Subnet Mask - The Subnet Mask determines which portion of an IP address is the network

portion, and which portion is the host portion.

Default Gateway - This is the IP address of the default gateway device that allows for contact

between the router and the network or host.

Status - The status of this entry, either Enabled or Disabled.

Modify – Click Modify to open Add or Modify a Static Route Entry page or Delete to delete

entry.

Add New… – Click this button to open Add or Modify a Static Route Entry page.

Enable All – Click this button to make all entries enabled.

Disable All – Click this button to make all entries disabled.

Delete All - Click this button to delete all entries.

Click the Next button to go to the next page, or click the Previous button return to the

previous page.

Add or Modify a Static Route Entry