Operation Manual

Cerberus ADSL2 Wi-Fi Plus (P6331-6)
53
Configuration / Advanced
Configuration options within the Advanced section are for users who wish to take advantage of
the more advanced features of the router. Users who do not understand the features should
not attempt to reconfigure their router, unless advised to do so by support staff.
There are six items within the Advanced section: Static Route, Static ARP, Dynamic DNS,
VLAN Control, Device Management and IGMP.
• Static Route
Click on Static Route and then choose Create to add a routing table.
Destination – The destination subnet IP address.
Netmask – Subnet mask of the destination IP addresses based on above destination.
Gateway – The gateway IP address to which packets are forwarded.
Interface – Select the interface through which packets are forwarded.
Cost – Represents the cost of transmission for routing purposes. The number need not
be precise, but it must be between 0 and 65535.
• Static ARP
Click on Static ARP and then choose Create to add a static ARP table.
Enter IP Address and MAC_Address of host which will be added to static ARP table.