Operation Manual

Cerberus ADSL2 Wi-Fi Plus (P6331-6)
23
• Wireless
Mode – 802.11b+g (Mixed mode), 802.11b and 802.11g. The factory default is
802.11b+g.
ESSID – Enter the unique ID given to the Access Point (AP), which is already built-in to
the router’s wireless interface. To connect to this device, your wireless clients must have
the same ESSID as the device.
Regulation Domain – There are five Regulation Domains for you to choose from,
including North America (N.America), Europe, France, etc. The Channel ID will be
different based on this setting.
Channel ID – Select the ID channel that you would like to use.
MAC Address – The AP’s MAC Address
AP Version – The Access Point firmware version.
Wireless Distribution System (WDS)
It is a wireless access point mode that enables wireless link and communication with
other access point. It is easy to be installed simply define peer’s MAC address of the
connected AP. WDS takes advantages of cost saving and flexibility which no extra
wireless client device is required to bridge between two access points and extending an
existing wired or wireless infrastructure network to create a larger network.
In addition, WDS enhances its link connection security in WEP mode, WEP key
encryption must be the same for both access points.
WDS Service – The default setting is Disable. Check Enable radio button to activate this
function.
Peer WDS MAC Address – It is the associated AP’s MAC Address. It is important that
your peer’s AP must include your MAC address in order to acknowledge and
communicate with each other.
Note: For MAC Address, Semicolon (:) must be included