Operation Manual

Cerberus P 6331-4A
8
Back Panel
DEFAULT
After the router is powered on, press this recessed button
using the end of paper clip or other small pointed object to
reset the router or to restore it to factory default settings.
LAN (RJ-45)
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the
four LAN ports when connecting to a PC or an office/home
network of 10Mbps or 100Mbps.
LINE (RJ-11)
Connect the supplied RJ-11 (telephone) cable to this port
when connecting to the ADSL/telephone network.
ON/OFF Power switch button.
PWR Connect the supplied power adapter to this jack.
Default Settings
Before changing configuration familiarize yourself with these default settings.
LAN/WLAN Ports
IP Address 192.168.1.100
Subnet Mask 255.255.255.0
DHCP Server Enabled
DHCP Server IP Address Pool
100 IP addresses
from 192.168.1.101
IP Address Lease Time 259200 seconds (72 hours)
User Name admin
Password pentagram
If you ever forget the password to log in, you may need to reset router to restore the factory
default settings. This procedure is described on the next page.