Operation Manual

Cerberus P 6331-4A
38
• Port Range – Enter destination port range.
• Source MAC – Enter source physical address (MAC).
• IP – Enter source IP address.
• Mask – Enter source subnet mask.
• Port Range – Enter source port range.
• Protocol ID – Select protocol: TCP/UDP, TCP, UDP, ICMP or IGMP.
• Vlan ID Range – Enter range of VLAN IDs.
• IPP/DS Field – Select packet priority standard: IPP/TOS (IP Precedence Range / Type of
Service) or DSCP (DiffServ Code Point).
• IP Precedence Range – Select range of IPP/TOS values (0-7).
• Type of Service – Select additional ToS parameter.
• DSCP Range – Select range of DSCP values (0 ~ 63).
• 802.1p – Select range of CoS values (0-7).
Action – This paragraph describes what action will be taken when rule parameters are true.
IPP/DS Field – Select packet priority standard: IPP/TOS or DSCP
IP Precedence Remarking – Will change IPP/TOS of a packet to selected value (0-7).
Type of Service Remarking – Will change additional ToS parameter of a packet to selected.
DSCP Remarking – Will change DSCP of a packet to selected value (0-63).
802.1p Remarking – Will change CoS value to selected (0-7). In second field you can specify
type a packet: Key Net Traffic (RIP, OSPF), Voice, Video, IGMP, Key Data.
Queue # – Select queue to which packet will be send.
When you are done making changes, click on SAVE to save your changes, DELETE to delete
the rule with the parameters you set or CANCEL to discard changes.
• QoS Settings Summary
In this window you can see all configured QoS rules