Operation Manual

Cerberus P 6331-4A
23
• Encapsulation
Select the encapsulation protocol your ISP uses. The following section will vary
depending on which encapsulation protocol you select.
• Dynamic IP Address
Select this option if your ISP provides you an IP address automatically. Please enter the
Dynamic IP information accordingly.
Encapsulation – Select your encapsulation type from the dropdown list.
NAT – Select whether NAT (Network Address Translation) is Enabled or Disabled.
Default Route – Select whether this PVC will be the default route for Internet data.
TCP MTU Option – Enter TCP MTU (Maximum Transmission Unit) Value here.
Dynamic Route – Select the RIP type and direction from the dropdown lists.
Multicast – Select the multicast protocol you wish to use from the dropdown list.
• Static IP Address
Select this option to set static IP information.
Encapsulation – Select your encapsulation type from the dropdown list.
Static IP Address – Enter the static IP Address here.
IP Subnet Mask – Enter the IP Subnet Mask here.
Gateway – Enter the Gateway address here.
NAT – Select whether NAT (Network Address Translation) is Enabled or Disabled.
Default Route – Select whether this PVC will be the default route for Internet data.
TCP MTU Option – Enter TCP MTU (Maximum Transmission Unit) Value here.
Dynamic Route – Select the RIP type and direction from the dropdown lists.
Multicast – Select the multicast protocol you wish to use from the dropdown list.