Operation Manual

Cerberus P 6331-4A

Finishing the Wizard

The Quick Start wizard now has all the information it needs. You MUST click NEXT, to save

configuration!

Click on BACK to make changes or correct mistakes. Click on NEXT to save the current

settings. Click on EXIT to exit the wizard without saving.

Your changes have been saved. Click on CLOSE. The Quick Start wizard window will close.

Interface Setup Tab

Glossary:

• RIP (Routing Information Protocol): Select this option to specify the RIP version,

including RIP1, RIP2-B and RIP2-M. RIP2-B & RIP2-M are both sent in RIP-2 format, the

difference is that RIP2-M using Multicast and RIP2-B using Broadcast format.

• RIP Direction: Select this option to specify the RIP direction. None is for disabling the

RIP function. Both means the ADSL Router will periodically send routing information and

accept routing information then incorporate into routing table. IN only means the ADSL

router will only accept but will not send RIP packet. OUT only means the ADSL router

will only sent but will not accept RIP packet.

• IGMP (Internet Group Multicast Protocol): It is a session-layer protocol used to

establish membership in a multicast group. The ADSL supports both IGMP version

IGMP-v1 & IGMP-v2. Select None to disable it.