Operation Manual

Cerberus ADSL Wi-Fi Lite
8
The Rear Ports
LINE (RJ-11)
Connect the supplied RJ-11 (telephone) cable to this port
when connecting to the ADSL/telephone network.
LAN (RJ-45)
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the
four LAN ports when connecting to a PC or an office/home
network of 10Mbps or 100Mbps.
DEFAULT
After the router is powered on, press this recessed button
using the end of paper clip or other small pointed object to
reset the router or to restore it to factory default settings.
PWR
Connect the supplied power adapter to this jack.
ON/OFF
Power switch button.
Default Settings
Before changing configuration familiarize yourself with these default settings.
LAN/WLAN Ports
IP Address 10.0.0.2
Subnet Mask 255.0.0.0
DHCP Server Enabled
DHCP Server IP Address Pool
12 IP addresses
from 10.0.0.2
IP Address Lease Time 259200 seconds (72 hours)
User Name
admin
Password
trendchip
If you ever forget the password to log in, you may need to reset router to restore the factory
default settings. This procedure is described on the next page.