Operation Manual

Cerberus ADSL Wi-Fi Lite
7
• Firmware Upgradeable: You can upgrade the router with the latest firmware through its
web-based GUI.
• High Speed Internet Access: downstream rates of up to 24Mbps and upstream rates of
up to 1Mbps. Cerberus ADSL Wi-Fi Lite is compliant with the following standards: ANSI
T1.413 issue 2, ITU-T G.992.1 (G.dmt), ITU-T G.992.2 (G.lite), G.994.1 (G.hs,
Multimode), ITU-T G.992.3 (ADSL2 G.dmt.bis), ITU-T G.992.4 (ADSL2 G.lite.bis), ITU-T
G.992.5 (ADSL2+; Annex A, I, J, L & M), Reach Extended ADSL (RE ADSL).
• Multi-Protocol to Establish a Connection: The router supports PPPoA (RFC 2364 - PPP
over ATM Adaptation Layer 5), RFC 1483/2684 encapsulation over ATM (bridged or
routed), PPP over Ethernet (RFC 2516) and IPoA (RFC1577) to establish a connection
with an ISP. The router also supports VC-based and LLC-based multiplexing.
Product Overview
Important Notes
• Do not use the router in high humidity or high temperatures.
• Do not use the same power source for the router as other equipment.
• Do not open or repair the case yourself. If the router is too hot, turn off the
power immediately and have it repaired at a qualified service center.
• Avoid using this product and all accessories outdoors.
• Place the router on a stable surface.
• Only use the power adapter that comes with the package. Using a
different voltage rating power adaptor may damage the router.
Front LEDs
LED Description
1
PWR
Lights when the power is ON.
2
WLAN
Lit green when the wireless connection is established.
Flashes when sending/receiving data.
3
LAN1
4
LAN2
5
LAN3
6
LAN4
Steady glow when connected to an Ethernet device.
Glows green for 100Mbps; Orange for 10Mbps.
Blinking light when data is Transmitted / Received.
7
ADSL
Lights when successfully connected to an ADSL DSLAM
Blinking when router is trying to connect to a DSLAM.