Operation Manual

Cerberus ADSL Wi-Fi Lite
44
Firmware
You can upgrade the firmware of the router in this page. Make sure the firmware you want to
use is on the local hard drive of the computer. It might take several minutes, don’t power
off it during upgrading. Device will restart after the upgrade!! After a success upload, the
system automatically restarts. Please wait for the device to finish restarting. This should take
about 2 minutes or more. You need to log in again if you want to access the device.
Current Firmware Version – This filed displays the current firmware version.
New Firmware Location – Type in the location of the file you want to upload in this field or
click Browse… to find it.
Click UPGRADE to begin the upload process.
SysRestart
The SysRestart screen allows you to restart your router with either its current settings still in
place or the factory default settings.
System Restart with – If you wish to restart the router using the factory default settings (for
example, after a firmware upgrade or if you have saved an incorrect configuration), select
Factory Default Settings to reset to factory default settings. Otherwise, you can select
Current Settings. You may also reset your router to factory settings by holding the DEFAULT
button on the back panel of your router in for 10-12 second while the router is turned on.
Click RESTART to start this process.