Operation Manual

Synchronize clock with GPS receiver - adjusts the
computer's system clock on the basis of information included
in the GPS signal.
For options Open port only when in use and Read COM
port in separate thread it is not recommended to change
the default settings, unless you are experiencing problems
with the connection to the GPS device. The default settings
are specified by AutoMapa.
Compensate signal delay - adjusts the position forecasting
"strength".
Ignore GPS Deviations - specifies the value of deviation of
your GPS position from the road network on the map to be
ignored, with the position still drawn at a section of the
closest road.
Reading frequency of GPS port - enables the setting of
time delay between subsequent readings of the GPS port.
The lower the frequency, the better the accuracy (but,
potentially, lower efficiency).
3.3.4 Voice messages - Settings
Volume
AutoMapa handles volume – device volume is specified by
the application.
Note: volume adjustment is made only for the time of
system playing the voice messages.
Constant message volume - volume slider allows you to
increase or decrease the volume of messages, which will not
be adjusted in accordance with the speed of your car.
Volume adjustment can also be executed automatically,
based on the vehicle speed. During fast drive, the interior of
the car is noisier than during slow drive. The settings shown
at the right-side of the screen should be interpreted as
follows: with the speed below 40 km/h, the volume remains
at the level of 50% and increases on a straight-line basis
once the speed exceeds 40 km/h, only to achieve the
maximum setting of 90% if the speed reaches 120 km/h. At
speeds greater than 120 km/h, volume remains at the level
of 90%.
Preferences
In this window you can select the language of voice instructions and voice messages. The "Test" button can be used to
check the current language and voice selection.