User Guide
Table Of Contents
- Preface
- Introduction
- Getting Started
- Using the LCD monitor
- Recording Images, Videos and Voices
- Playback
- Using the Setup Menu
- Making Connections
- Appendix
- Troubleshooting
- Specifications
Using Self-timer
The Self-timer allows you to take images after a pre-defined delay. While burst lets you take consecutive
shots. This function is only available in recording still images. The Self-timer setting is automatically set to
off when you turn off the camera.
Self-timer/Up button
To activate Self-timer:
• Press the Self-timer/Up button on your camera
repeatedly until your desired Self-timer mode is displayed
on the LCD monitor.
Self-timer is enabled
Your camera is equipped with three Self-timer modes:
Off. Captures an image without time delay.
10 Sec. Sets a 10-second delay to capture image after
pressing the Shutter button.
2 Sec. Sets a 2-second delay to capture image after
pressing the Shutter button.
Double. Performs delay and capture twice:
• Performs a 10-second delay, then captures the image.
• Performs another 2-second delay then captures the image
again.
Using Flash
When taking pictures in difficult lighting conditions, use the Flash/Right button to get correct exposure.
This function cannot be activated in recording videos or continuous shooting.
To activate Flash:
• Press the Flash/Right button on your camera r
until your desired flash mode is displayed on the LCD
monitor.
epeatedly
Flash/Right
button
Auto flash is enabled
Your camera is equipped with five flash modes:
Auto. The flash fires automatically whenever extra
lighting is needed.
Red-eye reduction. The flash fires twice to reduce t
red-eye effect.
he
Forced on. The flash fires whenever you press the
Shutter button regardless of lighting conditions.
Slow sync. The flash fires with a slow shutter speed.
Forced off. The flash is turned off.
• Flash function is only available in shooting still images, but not available in
Continuous shooting mode, HDR and Handheld night shot.
• Do not charge the flash while spinning the Zoom dial. Charge the flash after
releasing the zoom dial if necessary.
• The flash mode will remain at "Flash Off" if the flash does not open.
• When the flash is closed, flash mode is automatically set to flash off.
• When activating flashlight, the Flash won't pop up automatically. Please open the
Flash manually by pressing the Flash button.
20