Operating Manual

Appendix
61

About Folder and File Names
folder in the internal memory cards to organize
File
File names begin with "DSCI" and followed by a 4-digit number that increases in sequence. File numbering
st r is created.
If the highest folder number is 999 and the highest file number exceeds 9999, the camera will display the
w ng ways:
• Reset the file number. See "Setting File Numbering" on page 56.
Your camera automatically creates specific directory of
captured images, videos and audio files.
Naming
arts from 0001 when a new folde
arning message "Folder cannot be created". When this happens, try one of the followi
Do not change the folder and file names in the memory card using your PC. It may be unable
to playback the data using the camera.
Tro o nublesh oti g
Problem Cause and/or Action
Camera does not turn on.
• The battery may not be loaded correctly.
• The batteries may be exhausted. Charge or replace the batteries.
Cam
automatically.
have activated. Turn power back on.
ay be dead. Charge the battery.
era turns off
• Power Saving may
• The battery m
Power will not turn off.
Nothing happens when a
button is pressed.
Remove the battery from the camera and then reload it.
LCD Power button to turn on the LCD. turns dark Press any button excep. t the
Empty battery icon is
displayed on the LCD, then
the camera turns off.
Batteries are exhausted, please replace or recharge.
LCD m
"No image".
o image file in the memory card. Image file format may not be
supported.
onitor displays There is n
LCD monitor displays
"Not available for this file".
Function is only available for specific file types. File format is not
supported.
LC
"Me
s full. Replace the memory card with a new one or delete D monitor displays Memory card i
mory full". unnecessary images.
LCD monitor displays
"File locked"
This file is locked. Unlock the file. See "Protect" on page 47.
LCD monitor displays
"Card locked".
The memory card is protected. Remove the card and slide the
write-protect switch to its unlock position.
LCD monitor displays
"Format error".
The card may be damaged. You can either change the card or wipe to
clean the connected points.
LCD monitor displays
"Card error".
The memory card is protected. Remove the card and slide the
write-protect switch to its unlock position.
No image displays on the
TV screen.
Incorrect TV-out type was selected. Set the correct TV-out type to match
your TV system.
The lens got stuck up.
Do not force the lens to go back.
The type of the battery used may be incorrect or the battery power level
is too low. Change the battery or charge the battery before using the
camera.