Installation Instructions

ManualsBrandsPelonis ManualsAir Conditioners & AccessoriesThrough the Wall Air Conditioner Sleeve

THROUGH-THE-WALL AIR CONDITIONER

SLEEVE INSTALLATION INSTRUCTIONS

HOW TO ASSEMBLE THE WALL SLEEVE

SLEEVE HARDW ARE

ITEM DESCRIPTION QT Y

TOP PANEL

BOTT OM PANEL

LEFT SIDE P ANEL

RIGHT SIDE P ANEL

FRONT COVER P ANEL

REAR COVER P ANEL

BRACKET

CLASP FOR SLEEVE

SCREW ST3.9*10

WASHER

SLEEVE DIMENSION

SLEEVE INST ALLA TION

INST ALL THE UNIT

ASSEMBLE THE WALL SLEEVE

Use four screws to fasten the side panels on the bottom panel as shown

below.

NOTE:The arrow marks on the bottom panel indicate the direction of

indoor side

Place the top panel on the top and fasten with four screws as shown

below.

CLASP FOR SLEEVE

Insert the four clasps for sleeve into the quadrate holes in the side panels

as shown below.

SLEEVE

INSIDE

OUTSIDE

WALL

Remove the old air conditioner from the existing wall sleeve and remove

the existing wall sleeve.

Prepare and install the new wall sleeve into the wall opening.

The wall sleeve must be fastened in the wall secuerly before installing the

new air conditioner.

Keep the cover panels for later use to protect the sleeve from rainy or

windy weater.

To avoid distortion to the front panel of the air conditioner,the sleeve

should be installed at a distance of 4 minimum from heating source.

(e.g.Baseboard heating,radiator.etc.)

After sleeve has been installed,caulk where necessary entire perimeter

around exterior wall opening and sleeve.Use a good grade of caulking

compound to seal all cracks against air and water infiltration.

The rear grill and washer scerws should be kept well until the air conditio-

ner is installed.

Insert the louvered rear grille or the expanded rear grille (packed with air

conditioner you purchased) and fasten with 4 washer screws as shown

below.

Expanded rear grille Louvered rear grille

Summary of content (2 pages)

PAGE 1
THROUGH-THE-WALL AIR CONDITIONER SLEEVE INSTALLATION INSTRUCTIONS INST ALL THE UNIT Remove the old air conditioner from the existing wall sleeve and remove the existing wall sleeve. Prepare and install the new wall sleeve into the wall opening. The wall sleeve must be fastened in the wall secuerly before installing the new air conditioner. Keep the cover panels for later use to protect the sleeve from rainy or windy weater.
PAGE 2
ASSEMBLE THE WALL SLEEVE (CONTINUED) Install two brackets on the top and one bracket on each side of the sleeve, fasten with four screws.There are two methods for your choice to install the brackets as shown in FIG. A and FIG.B. NOTE: Choose anyone hole in the bracket as you prefer to fasten the screws on the sleeve. INSTALL THE COVER PANELS(CONTINUED) FIG.D FIG.A FIG.B NOTE:To improve the firmness of the sleeve, it is recommended to install 8 more screws as shown below. FIG.