Use and Care Manual

OPERATING INSTRUCTIONS

MAINTENANCE INSTRUCTIONS

The fan requires little maintenance. Do not try to fix it by yourself. Refer it to

qualified service personnel if service is needed.

1. Before cleaning and assembling, do not plug the pins into the socket.

2. To ensure adequate air circulation to the motor. Keep vents at the rear of the

motor housing from dust and fluff. A vacuum cleaner can not be used to

clean these vents before unplugging. Do not disassemble the fan to remove fluff.

PART NAMES

1. Body

2. Rear base

3. Front base

4. Base clip

5. Power cord

PARTS ASSEMBLY

1. Pull power cord (5) out slightly.

2. Put the rear base (2) on the body (1) by inserting the cylinders under the

body to blind holes on rear base as shown on diagram.

3. Put front base on rear base (2) and fix the body, the rear base and front base

by base clip (4) as shown.

a. Control parts description:

1. Timer 2. Body oscillating switch 3. Speed switch

b. Instructions:

1. Plug the power cord into a wall outlet.

2. The air flow can be angled to the left or right by

pushing the button of body oscillating switch (2).

If you want to stop angling, push it again.

3. Automatic 120-minute timer. Turn the knob of the

timer (1) to the desired time you want, the fan will stop

when the time is over. The longest timer setting is 120

minutes. If the timer is not in use, set the timer to " ".

4. Speed is controlled by pushing speed switch (3) on the

top of the body. There are 4 positions:

0--Off; 1--Low; 2--Medium; 3--High

0 1 2 3

4080

120