Use And Care Manual

Page 7
Operating
Instructions
Control Panel Features
Swing Button (optional)
(Applicable to the models with auto swing
feature only)
Used to initiate the Auto Swing feature.
When the operation is ON, pressing the
SWING button can stop the louver at the
desired angle.
Timer button
Used to initiate the AUTO ON start time
and AUTO OFF stop time program,
in conjunction with the + & - buttons.
The timer on or off light will illuminate
depending on the selected setting.
Mode button
Selects the desired operating mode.
Each time you press the button, a mode
is selected in a sequence that goes
from AUTO, COOL, DRY FAN and HEAT.
The mode light illuminates and indicates
the selected mode. (cooling only models
excluded)
Up (+) and Down (-) buttons
Used to adjust (increasing/decreasing)
temperature settings in 1°C/1°F
increments in a range of 17°C/62°F to 30°
C/86°F or the TIMER setting in a range of
0 ~ 24hrs.
NOTE
The control is capable of displaying
temperature in degrees Fahrenheit or
degrees Celsius. To convert from one to
the other, press and hold the Up and
Down buttons at the same time for 3
seconds.
Fan/Constant fan
Control the fan speed. Press to select the
fan speed in four steps-LOW, MID(MED),
HIGH and AUTO. The fan speed indicator
light illuminates under different fan
settings.
NOTE
In cooling or Dry mode, press the button
for 3 seconds to turn on or off the
constant fan function. When the function
is turned on, the constant fan light will
illuminate, identifying the fan continuous
run for cooling. When the function is
turned off, the constant fan light will go
out, identifying the fan cycle run with
compressor stop.
Sleep/Filter button
Used to initiate the SLEEP
operation.
Operating Instructions
Constant fan
Constant fan
(Press 3s)