Operating Guide

OPERATING INSTRUCTIONS

Fig.8

Fig.9

II. Control Panel (Fig.9)

To make the fan oscillate, press the clutch knob located on the

top of the motor housing. To get the directional airflow, pull the

clutch knob up to its initial position.

III. Oscillation Control

To adjust the air flow upward or downward, push the grilles

lightly to the desired direction.

IV. Tilt Adjustment

“ ” ON/OFF KEY

The key is for switching on the fan. The fan will be started at low

speed. Press the key again, it will be switched off.

“ ” TIMER KEY

When this key is touched repeatedly, the time to be set 1,

2 and 4 hours and the correspond pilot lamp will light. If the

lamp don’t light after you touched the key, the fan will run

continuously.

“ ” SPEED KEY

After the fan has started, this key serves as a speed selector in the sequence from

“low-medium-high-low” when this key being touched repeated or continuously.

“ ” MODE KEY

Press this key to select mode. This key is a selector key for wind type. The wind

type changes in the sequence from NORMAL---NATURAL---NORMAL wind when

this key being touched repeatedly or kept in.

I. Remote Controller (Fig.8)

Clip

Fig.5 Fig.6 Fig.7

Press the lower center button to Start and Stop fan and to

select Low, Medium or High fan speed. Press the middle center

button to select 1, 2 or 4 hour automatic shutoff time period

of operation.

NOTE: There is no Mode key on the control panel. Mode

function must be activated from the remote control.