Data Sheet

0350
Protector
Cube Case
Sensitive equipment needs protection, and since 1976 the answer has been
the Pelican™ Protector Case. These cases are designed rugged, and travel
the harshest environments on earth. Against the extreme cold of the arctic or
the heat of battle, Pelican cases have survived.
Made in the USA, these tough cases are designed with an automatic purge
valve, that equalizes air pressure, a watertight silicone O-ring lid, over-
molded rubber handles and stainless steel hardware.
• Personalized nameplate service available
• Large 2-person fold down handles
• Watertight, crushproof, and dustproof
• 3 level Pick N Pluck™ with convoluted lid foam
• Automatic Pressure Equalization Valve - balances interior pressure, keeps
water out
• Lifetime Guarantee of Excellence
• O-ring seal
• Open cell core with solid wall design - strong, light weight
• Stainless steel hardware and padlock protectors
CONFIGURATIONS
0350
Standard
0354
With Padded Dividers
0350NF
No Foam
0350WF
With Foam
DIMENSIONS
Interior (L×W×D) 20.00 x 20.00" x 20.00 (50.8 x 50.8 x 50.8 cm)
Exterior (L×W×D) 22.50 x 22.43" x 21.25 (57.2 x 57 x 54 cm)
Lid Depth 5.00" (12.7 cm)
Bottom Depth 15.00" (38.1 cm)
Total Depth 20" (50.8 cm)
Int Volume 4.63 ft³ (0.131 m³)
MATERIALS
Body Polypropylene
Latch ABS
O-Ring Polymer
Pins Stainless Steel
Foam 1.3 lb Polyurethane
Purge Body ABS
Purge Vent 3 Micron Hydrophobic Non-Woven