User Guide

IAPMO RESEARCH AND TESTING, INC.
5001 E. Philadelphia Street, Ontario, CA 91761-2816 • [phone] • Fax [phone] • www.iapmort.org
CERTIFICATE OF LISTING
IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a
combination of both to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the supplier's
factory and warehouses as well as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in the characteristics
below and is not to be construed as any recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product acceptance by Authorities
Having Jurisdiction.
The most updated information on this Certificate of Listing is available online at pld.iapmo.org
Effective Date: December 2017 Void After: December 2018
Product: Drinking Water Treatment Unit - Aesthetic Effects File No. W-10918
Issued To: PELICAN WATER SYSTEMS
3060 PERFORMANCE CIRCLE STE. 2
DELAND, FL 32724
Identification: Each product shall be permanently and legibly marked by means of a permanent plate(s) or
label(s) affixed in a readily accessible location to the system. This information shall
include the model number, name and address of manufacturer, functional description of the
system, maximum working pressure in kPa (psig), maximum operating temperature in degrees C
(degrees F), and a statement noting that the system conforms to NSF/ANSI 42 for the
specific performance claims
as verified and substantiated by test data. Where applicable and appropriate, the
information shall also include the model number of replacement components, electrical
requirements, and a statement (or its equivalence) for activated carbon systems: "Do not
use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system."
Product shall also bear the UPC® certification mark.
Characteristics: Point-of-use and point-of-entry systems intended to reduce substances affecting the
aesthetic quality of the water or to add chemicals for scale control, or both. To be
installed in accordance with the manufacturer's installation instructions and the
requirements of the latest edition of the Uniform Plumbing Code®.
Products listed on this certificate have been tested by an IAPMO R&T recognized laboratory.
This recognition has been granted based upon the laboratory's compliance to the applicable
requirements of ISO/IEC 17025.
Products are in compliance with the following standard(s):
NSF/ANSI 42-2016
Brand Name Model Number
Capacity
(Gallons)
Flow Rate
(GPM)
Reduction Claims