User manual

STORAGE OPERATION
1. To dose, ensure light head is facing upwards and fully collapse the mast,
2. Pull the deployment collar upwards sharply (to dislocate it - see Fig. 4)and continue sliding the collar up until it
runs out
of travel. The legs can then all be pushed inwards and will automatically latch in place .
Fig. 4
PRODUCT SPECIFICATION:
Lamp type: 2 X Cree XML LEDs producing 1200 lumens at source
Battery type: 7.2V
Li Ion removable, rechargeable battery
Burn time: 2 hours minimum
Charging time: less than 2 hours
BATTERY STATUS INDICATION
The on/ off switch includes an illuminated battery status indicator.
Green = 50 - 100% capacity
Orange
=
10 - 50% capacity
Red
=
o - 10% capacity
CHARGING:
Light fully deployed - approx. 5ft or 1500mm
& CAUTION: USE APPROVED CHARGER ONLY AND ALWAYS REMOVE BATTERY FROM CHARGER ONCE
IT IS FULL Y CHARGED.
1. Remove the battery from base of product by pressing the two yellow latches simultaneously and pulling it from
the housing.
2. Plug the power supply into the mains socket (or 12V vehide charger plug into cigarette lighter socket) and the
small plug into the jack into the side of the charger. Switch on AC mains/ vehicle power. Insert battery into the
charger (using the yellow tabs on the top of the battery pack to line up with the yellow charger latches to ensure
correct orientation, see Fig. 5.) secure it
in place using the latches and observe the LED status. Do not force the
battery pack into place; it should locate easily. If there is resistance, there
may be an obstruction!
•' _____________ .. '