Specification

Dual-Mode Pull-Down Sprayer
Model# PD222-SS
Stainless Steel PVD
Warranty
The manufacturer warrants this faucet to be free from
defects in workmanship and material present at time
of shipment from the factory for a limited lifetime
from the date of purchase. This warranty applies only
to the original purchaser. The manufacturer agrees
to correct such defects at no charge or, at our option,
replace the faucet with a comparable or superior
model. You may be required to present a copy of your
sales receipt as proof of purchase. All cost of removal
and reinstallation are the expressed responsibility of
the purchaser. Any damage to the faucet by accident,
misuse or improper installation, or by axing
accessories not produced by the manufacturer, are the
purchaser’s responsibility. The manufacturer assumes
no responsibility whatsoever for faucet installation
during the warranty period. There is no further
expressed warranty. The manufacturer disclaims any
and all implied warranties. The manufacturer shall
not be liable for incidental, consequential or special
damages arising at or in connection with product use
or performance except as may otherwise be accorded
by law. This warranty gives you specic legal rights,
and you may also have other rights which vary from
state to state, province to province. This warranty
supersedes all prior warranties.
Features
• Stainless steel PVD nish
• Ceramic disc cartridge
• Dual-mode sprayer
• Lever style handle
• Integrated supply lines with 3/8” compression
connections
• Max ow rate: 1.8 GPM @ 60 PSI
Codes and Standards
Specied model meets or exceeds:
• ASME A112.18.1 / CSA B125.1
• NSF 61 Section 9
• IAPMO / UPC listed
• AB1953 low lead
• Watersense approved
• ADA compliance to ANSI A117.1
Installation Notes
• Requires 1-1/4” min to 1-3/4” max hole diameter
• Maximum counter thickness: 1-7/8”
• Installs in 1, 2, 3, or 4 holes
11”
(225mm)
(208mm)
(592mm)
(331mm)
(95mm)
(72mm)
8 3/16”
23 5/16”
13 1/16”
3 3/4”
2 13/16”
7 15/16”
4 1/4”
(201mm)
(108mm)
2 1/2”
1 9/16”
3 1/2”
5 9/16”
4 1/8”
(142mm)
(104mm)
26.6°
M25X1.25
2 5/16”
10 3/16”
9/16-24UNEF
3/8” Compression
(1mm-38.1mm)
1/16”-1 1/2”
(59mm)
(258mm)
(89mm)
(63mm)
(O 39mm)
(543mm)
21 3/8”
(280mm)
8 7/8”