Installation Guide

Page 4/6
STEP 3
} With the help of another person, move the assembly unit desired location and level the
top by adjusting the threaded feet.
} Use a pencil (not included) to mark the pre-drilled holes on Vanity Top (A) or Rear, Upper
Cross Bar (D) onto the wall.
} Set assembly unit aside. Use a 3/8" drill bit (not included) to drill 3/8" pilot hole on the
marked location.
} Insert Anchors (3) into holes until they are ush with the wall, then move assembly unit
back into position.
} Secure item to the wall by inserting the screws (2) through Vanity Top (A) or Rear, Upper
Cross Bar (D) into the Anchors (3).
NOTE: Anchors are included, but be sure to use the appropriate anchors for the wall material.