Installation Guide

Notes:
TRADITIONAL FLOOR MOUNT TUB FAUCET
1. Faucet is not for use on concrete floors.
2. Please ensure all local plumbing codes are observed during installation
3. Water supply lines must be roughed in on 8” centers.
Step 1
Attach spout by loosening setscrew in the back of the
faucet body, and inserting the spout inside the body
until flush. Tighten the setscrew .
Step 3
Attach hot and cold risers U-FRSR to union nuts
on back of faucet body using one #10 rubber
gasket on each riser.
Step 4
Attach #1 hand shower holder with
#2 rubber gasket to outlet above
diverter handle.
Step
2
Screw #11 handle hub onto hot/cold cartridges
#9 and #17. Disassemble handle and install
onto cartridge by securing with screw included.
Reassemble handle.
NSF /ANSI 61
5
1
2
Setscrew
Spout
T-HCRS
T-HPLV
11
White Porcelain
11
T-HLVR
9
11
17
T-FB1
Union Nut
Washer (10)
U-FRSR