Operation Manual

GB 24
What you need to consider
Safety instructions for the installation
• The connection must comply with national and local regulations.
• The appliance must always be earthed.
• This appliance may only be connected by a competent electrical
installer.
• The connection cable must hang freely and is not to be fed through
a drawer.
• If you want to make a fixed connection, make sure that a multi-
polar switch with a contact separation of at least 3 mm is fitted in
the supply line.
• The worktop the hob is built into must be flat.
• The walls and the worktop surrounding the appliance must be heat
resistant up to at least 85 °C. Even though the appliance itself does
not get hot, the heat of the hot pan could discolour or deform the
wall.
• Damage caused by incorrect connection, installation or use, will not
be covered by the guarantee.
• The wall socket and plug must be accessible at all times.
• Ensure that the power cord will not come in contact with parts that
can become hot.
• Do not use an adapter or an extension lead to connect the
device to the electrical mains. Safe use of the device cannot be
guaranteed with these accessories.
• Installation, maintenance or repairs should only be carried out by
professionals who are authorized by the manufacturer, as failure to
do so will void the warranty.
• Disconnect the electricity from the appliance before starting any
repair work. Preferably unplug the appliance, switch the (automatic)
fuse(s) off or, in the event of a permanent connection, set the
switch in the power supply lead to zero.
• Faulty parts may only be replaced by original Pelgrim parts.
Only those parts are guaranteed by Pelgrim to meet the safety
requirements.
• If the connecting cable is damaged, it may only be replaced by the
manufacturer, the manufacturer’s service organisation or equivalently
qualified persons, in order to avoid dangerous situations.
INSTALLATION