Operation Manual

EN 9
OPERATION
Boost
The ‘Boost’ function is used to cook at maximum power for a short
period of time (maximum 10 minutes). The power is reduced to setting
9 at the end of the maximum boost time.
Switching on the boost function
The hob is switched on and a pan is on the cooking zone.
1. Touch the P button. (You can also use this button if a power has
been set).
2. Touch the - or the + button for the desired cooking zone.
The display shows ‘P.’. The boost function is immediately active.
If the + or the - buttons are not touched, the red light to the right
above the P button will flash for 3 seconds and then stop. You will
hear a single bleep.
Switching off the boost function
The boost function is switched on, the display shows ‘P.’.
1. Touch the - button.
The display shows power setting 9, the boost function is switched
off. Or:
2. Touch the + or the - button at the same time.
The display shows setting ‘0.’, and the cooking zone is switched off.
• Two cooking zones that are behind each other influence each other.
The power is automatically distributed when these cooking zones
are used at the same time. This does not have any consequences
up to setting 9. Selecting the Boost setting for one of the cooking
zones, however, automatically switches the other cooking zone to
a lower setting. If one of the cooking zones is set to boost and you
want to set the other zone to setting 9 or Boost, the cooking zone
that is set to boost will automatically be switched to a lower setting.
• Two cooking zones that are beside each other do not influence
each other. You can set both cooking zones to Boost.